Common troubleshooting methods for swing gates and wing gates

Swing gates, wing gates and other access gates are very common gates. They are widely used in places and are used at a high frequency. Swing gates, wing gates and other access gates are generally not easy if they are carefully maintained There is a big problem.

However, small-probability events are not necessarily easy to occur. Maintenance staff should understand some of the latest common fault solutions, which will occur during normal maintenance. Many conveniences.

1. After the card is swiped at the swing gate, wing gate and other channel gates, the swing gate does not open and close the door, there is no response, or it does not open automatically after the power is turned off, check again, whether the open signal line has fallen, and inquire the main Is the open signal indicator on the board connected to an open data signal? 2. After swiping the card for consumption, the sluice gate is opened, but the sluice gate is not closed.

This kind of thing is generally the anti-pinch infrared in the middle is not right. Before fixing the main box, make sure that the infrared rays are properly aligned. , so that everything can be opened and closed normally.

If the infrared rays are not properly aligned, an alarm will be sent to remind you when the power is turned on. After swiping the card, follow the direction arrow to drive. 3.

After swiping the card at the channel gate for consumption, one is open, and the other is not. Check again to see if the synchronization line is connected. Make sure that after the connection is done, whether the motherboard of the one that cannot be seen is connected to the switch If there is no data signal, check again whether the wiring has fallen and whether the power plug on the motherboard is properly inserted.

4. Swing gates, wing gates and other channel gates are marked with the working attitude of the orientation sign, respectively, the green arrow symbol is biased to the left, biased to the right, or a bright red cross. If the orientation indication does not reflect, or the orientation indicated is wrong.

You can switch to another test and try it with a good swap. Check the wiring again.